Rangemaster RMB610PBL/SS User Manual & Installation & Service Instructions page 15

Setting the Pyrolytic
This oven can clean itself by a process known as pyrolysis,
heating the cavity to a temperature of approximately 480˚C.
This will burn off the residue from spattering and spillages
caused by cooking.
Pyrolytic programmes should be used when the oven smokes
during preheating or cooking or if the oven smells even when
cold. It is not necessary to run a pyrolytic programme after
every use of the oven.
It is good practice to leave the windows and doors open to
allow for good ventilation.
There are three options see Table 4.1. The programme
immediately locks the door and starts the cooling fan at a
slow setting; the cooling fan speed increases to its maximum
when the oven heat builds up.
Once the pyrolysis has been sent you cannot not cancel the
setting other then turning it off from the mains.
DO NOT leave the oven unattended while in
n n
pyrolytic mode.
DO NOT wait until the oven is coated in grease to
n n
run a pyrolytic programme. The smoke produced
by pyrolysis is broken down by passing through a
catalyser.
Before any pyrolytic programme, remove all shelves,
n n
trays and other accessories from the oven and
clean up any major spills to avoid the risk of fire or
excessive smoke.
DO NOT hang towels or cloths on the oven handle
n n
during pyrolysis.
Selected Time
1:15 h
1.30 h
2:00 h
Type
Light
Normal
Intense
Table 4.1
Conventional
Grill
Fan Grilling
Duo
Rapid
Defrost
Pyrolytic
Setting
Duration
1:15 h
1:30 h
2:00 h
Pyrolytic
11
12:00
2015/01/01
12:00
12:00
12:00
OK
12:00
Please remove all accessories
from the oven interior before
starting self clean!
OK
12:00
Pyrolytic
Time left 02:00
Step. 1
Step. 2
Step. 3
Step. 4
Step. 5
Step. 6