Message Lists - Sony Cineza VPL-HS50 Operating Instructions Manual

Message Lists

Warning messages
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the LAMP.
Please replace the filter.
High temp.!
Probably use in high
altitude. Switch to high
altitude mode on? Yes: O/
No: o
Caution messages
Message
x
Not applicable!
Cause and Remedy
c Turn off the power.
c Check to see if nothing is blocking the ventilation holes.
c Input a signal that is within the acceptable range of the
frequency.
c Set the output signal on an external monitor of the connected
computer to SVGA.
c Set "Input-A Signal Sel." in the Setup
"Computer". (1 page 42)
c Set "Input-A Signal Sel." in the Setup
"Computer" when RGB signal is input from the computer. (1
page 42)
c It is time to replace the lamp. Replace the lamp. (1 page 48)
c It is time to replace the air filter. Replace the air filter. (1 page
49)
c When using the projector at an altitude of 1,500 m or higher:
select "Yes" to set to "High Altitude Mode". (1 page 41)
c If this message is displayed when using the projector at an
altitude of less than 1,500 m: check to see if nothing is blocking
the ventilation holes.
Cause and Remedy
c No signal is input in the selected input. Check connections. (1
page 13)
c Press the appropriate button.
menu to
menu to
47
Troubleshooting
GB