Gas Control Module System; Replacement Parts; Technical Service - Superior VRE3236ZENWS Installation And Operation Instructions Manual

GAS CONTROL MODULE SYSTEM

REMOTE CONTROL FEATURE
The module has a built in remote control receiver that allows the user
to program the remote transmitter at any time during or after the instal-
lation of the burner.
1. There is a switch located on the right side of the module that reads
REMOTE/OFF (Figure 29).
2. When the remote/off switch is in the OFF position, the burner will
operate from the rocker switch or wall switch connected to the two
BROWN wires on the module.
3. When the remote/off is in the REMOTE position the burner will operate
from the Remote Control Transmitter.
NOTE: The module must be programmed to the Remote Control Trans-
mitter.
• To program the module (make sure the system has power), locate
the learn button (Figure 30) on the module. Locate the metal shield
that is covering the module and remove the screw on top. Use a
small thin object like a paper clip (not sharp points) to press and
release the learn button. There will be a beep sound from the module.
Then press any button on the remote transmitter. Once the module's
internal receiver accepts the transmitter code, there will be a series
of confirming beeps.
• The remote system is ready for use.
• Pushing and holding the LEARN button for 6 seconds will result in
clearing the transmitter security code from the module's memory.
The module will make three long beeps in succession when it has
been cleared.
REMOTE CONTROL "DRY-OUT" FEATURE
The remote/Ignitor has a special feature. It will allow heat from the burner
to dry the probe and burner assembly due to excess moisture, caused
by rain, humidity or condensation. To activate:
• Press and hold the HI and LO buttons on the transmitter for 30-45
seconds. This allows the sparking to start and the burner to ignite.
• Release the HI and LO buttons, after the allotted time, sparking will
stop and the burner will go out.
• Press and hold the ON button and sparking will start again and
burner should ignite.
• Release the ON button. The sparking will stop, and the burner
should stay ON.
• Repeat if necessary.
Remote/Off Switch
"S" Pilot Connection
AF-4000 MOD Module Rt Side
Figure 29 - Gas Module Right Side
ADJ.
"I" Pilot Connection
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Learn Button
AF-4000 MOD Module Lt Side
Figure 30 - Gas Module Left Side

REPLACEMENT PARTS

NOTE: Use only original replacement parts. This will protect your
warranty coverage for parts replaced under warranty.
Normally, all parts should be ordered through your IHP distributor
or dealer. Parts will be shipped at prevailing prices at time of order.
NEVER USE SUBSTITUTE MATERIALS. USE OF NON-APPROVED
PARTS CAN RESULT IN POOR PERFORMANCE AND SAFETY
HAZARDS.

TECHNICAL SERVICE

You may have further questions about installation, operation, or
troubleshooting. Please contact your IHP dealer for any questions
or concerns. When contacting your dealer please have your model
and serial numbers of your appliance ready. You can also visit our
web site at SuperiorFireplaces.us.com
AUX Connection
19