Safety Notes For Using Pneumatic Devices - Parkside PDWE 8 A1 Operation And Safety Notes Translation Of The Original Instructions

... / Safety notes for using pneumatic devices

Any changes to the pneumatic
maintenance unit exclude liability of
the manufacturer and any connected
damage.
Safety notes for using
pneumatic devices
Important!
Always keep the compressed air
„ z
hose firmly in your hands when
releasing a connection. The lash-
ing backlash of the compressed
air hose may cause injury.
The compressed air maintenance
„ z
unit must be installed before it can
be safely taken into operation. A
stable wall is suitable for installa-
tion (with screw connections).
We recommend only using
„ z
the lubricants specified by the
manufacturer.
Never exceed the indicated
„ z
maximum pressure values of the
maintenance unit.
The pneumatic maintenance unit
„ z
must only be connected to a com-
pressed air source that does not
exceed the working pressure of
8 bar.
Do not put the compressed air
„ z
lines near any heat, oils, heat and
sharp edges.
The maintenance unit must only
„ z
be operated in connection with a
8 GB/IE/NI
pneumatic compressor.
Use of other compressed air
sources, such as a compressed air
cylinder, is forbidden. There is a
danger of fire and/or explosion.
Make sure that children and
„ z
persons with limited physical or
mental capacities are kept away
from the maintenance unit and the
connected compressed air tools.
Only use genuine spare parts for
„ z
repairs. Any non-genuine spare
parts may cause severe damage.
When conducting any mainte-
„ z
nance, setting and repair work,
always disconnect the mainte-
nance unit from the compressed
air supply first.
Changes to the maintenance unit
„ z
are forbidden.
Use the maintenance unit only
„ z
when it is in an impeccable con-
dition. In doubt, use a specialist's
advice.
Have repairs only conducted by
„ z
qualified specialists.
User safety
Try out the pneumatic tool
used before every use. Never
use the compressed air maintenance
unit with any higher operating
pressure then indicated in the tech-
nical data. Before you connect your
pneumatic tools to the pneumatic