Ricoh Aficio MP201SPF Service Manual page 464

Bit Switches
I-fax Switch 04 [SP No. 1-102-005]
No FUNCTION
Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the
RTI/CSI of the originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI
0
or CSI is used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the
Subject line that indicates where the transmission originated can be used to
determine automatically the destination folder for each e-mail.
Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following
three cases:
1) When the service technician sets the service (software) switch.
1 2) When memory sending, delivery specified by F code or SMTP reception is done.
3) With relay broadcasting (1st stage without the Schmidt 4 function).
This switch does not apply for condition 3) when the RX system is set up
for memory sending, delivery by F-code, sending with SMTP RX and when
operators are using FOL (to prevent problems when receiving
transmissions).
2-7 Not Used
D115/D116
COMMENTS
5-26 SM Appendix