Hilti SF 6-A22 Original Operating Instructions page 14

5.6 Installing Hilti bit holder (optional)
1. Remove the battery. → page 8
2. Insert the bit holder into either the left or right opening provided at the base of the product.
3. Secure the bit holder with the two screws.
4. Insert the battery. → page 8
5.7 Hilti Installing the retaining strap (optional)
ATTENTION
Damage to the product and / or the lanyard. Incorrect handling can result in damage to the product and/or
lanyard.
▶ Do not use a metal chain as a lanyard. Do not use lanyards longer than 2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to use the Hilti retaining strap.
The retaining strap allows a securing cord or lanyard to be attached.
When working with the product, you must comply with national regulations for working at heights.
1. Remove the battery. → page 8
2. Insert the two tabs on the retaining strap into the slots on each side of the base.
3. Secure the retaining strap with the screws supplied.
4. Insert the battery. → page 8
10 English
Printed: 11.12.2018 | Doc-Nr: PUB / 5467444 / 000 / 00