Table of Contents
Advertisement
Available languages
Available languages
♦
Switch the appliance on by pressing the ON/
OFF switch
.
♦
Set a speed suitable for the work using the
speed control
.
♦
Switch the appliance off by pressing the ON/
OFF switch
again .
Grinding
♦
Place the workpiece on the tool rest
the workpiece slowly towards the grinding disc
at the required angle until the workpiece
and the grinding disc
each other .
♦
Move the workpiece evenly backwards and
forwards in order to achieve optimal results . This
also ensures that the grinding disc
down more evenly .
Changing the grinding disc/buffing disc
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
WARNING!
►
The grinding
or buffing disc
not be any larger than the prescribed diameter .
►
Replace the grinding
when the outer diameter is less than 50 mm .
NOTE
►
Please note that you will require tools which
are not included in delivery for the assembly .
♦
Using a Phillips screwdriver, unscrew the fixing
bolts
from the side protective covers
E) . Remove the protective covers
♦
If you want to change the buffing disc
remove the locking pin
on the flexible shaft
ment of the flexible shaft
♦
Unscrew the union nut
using a 17 mm wrench . Hold the affected grind-
ing
or buffing disc
create a suitable counterpressure .
■
12
│
GB │ IE │ NI │ CY
. Guide
come into contact with
is worn
used may
or buffing disc
(see fig .
on both sides .
,
from the attachment
38a
. Then pull the attach-
off the shaft
.
from the shaft
firmly in one hand to
♦
Remove the tension disc
or buffing disc
.
♦
Place the new grinding
the shaft
.
♦
Push the tension disc
♦
Screw the union nut
♦
Re-tighten the union nut
or buffing disc
that you have just attached
firmly in one hand to create a suitable counter-
pressure .
WARNING! RISK OF INJURY!
►
Never use the grinding
without the protective cover
CAUTION! PROPERTY DAMAGE!
►
Do not tighten the union nut
since the grinding disc
break .
♦
Refit the protective cover
by tightening the fixing screws
Fitting the flexible shaft
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
♦
Screw the flexible shaft
thread
of the appliance . To do this, push the
axle core of the flexible shaft into the square
hole on the connecting thread
ing nut
anticlockwise to tighten it .
WARNING – RISK OF INJURY!
►
Make sure that the eye shields
down to the tool rests
unintentional contact with the grinding
buffing disc
.
►
After use, remove the flexible shaft
the appliance . Otherwise, the flexible shaft
could start thrashing about in an uncon-
trolled manner and cause an injury when you
switch the appliance on .
and grinding
or buffing disc
on
back onto the shaft
back onto the shaft
. Hold the grinding
or buffing disc
.
too tightly
could otherwise
and fix it in place
.
onto the connecting
. Turn the lock-
are folded
. This can prevent
or
from
PDFW 120 A1
.
.
Advertisement
Chapters
Table of Contents
