Setup Menu Functions - Bosch ACS 561 Repair Instructions

Introduction

Setup Menu Functions

Access the following functions by pressing the
Menu key and selecting Setup.
ss01374
Figure 1-3. Setup Menu
Calibration Check
Use to verify internal scale calibration. Refer to
Calibration Check in the Maintenance section.
Edit Print Header
Programs information that will appear on the
printout each time a print function is used.
Pump Maintenance
Displays how long the vacuum pump has oper-
ated since the last oil change, and the amount
of time remaining until the next oil change is
needed. For maximum vacuum pump perfor-
mance, change vacuum pump oil every time the
filter is replaced. Refer to the Change Vacuum
Pump Oil in the Maintenance section.
Date and Time Setup
Program the machine for current date and time.
Filter Maintenance
The filter removes acid, particulates, and mois-
ture from the refrigerant. To meet requirements,
it is mandatory to replace the filter after 150 kg
(331 lbs.) of refrigerant has been filtered.
This menu item displays the filter capacity re-
maining until the machine locks down and no
longer functions. Refer to Filter Change in the
Maintenance section.
When the filter is replaced, refer to Change
Vacuum Pump Oil in the Maintenance section
of this manual.
SP00D00517 2018-07-11
Flush Hoses
Flushes residual oil from the machine to pre-
pare for the service of next vehicle.
Select Language
Select a language for screen prompts. English
is the default language.
Oil Inject Adjust
Variables affect the accuracy of oil injection.
Use this menu item to adjust the oil inject
correction factor when using very high or low
viscosity oils, or if the machine is operating in
very high or low ambient tempuratures. Refer
to Oil Inject Adjust in the Maintenance section
of this manual for instructions.
Production Menu
For Bosch production use only.
Refrigerant Management
Displays the amount of refrigerant recovered,
charged, and replenished (for the life of the ma-
chine), and filtered since the last filter change.
Service Menu
For Bosch service center use only.
Select Units
Program the machine to display units of mea-
sure in kilograms or pounds. The default display
is kilograms.
System Flush
Provides a method of removing oil by forcing
liquid refrigerant through an A/C system or
components of an A/C system. After flushing,
the refigerant is recovered by the machine and
filtered by the recycling circuit.
System Information
Displays versions of software, firmware, and
hardware used in the unit. Also displays lan-
guages available. This information is entered
into the system when software is initially loaded
and changes where necessary with any soft-
ware updates. Firmware and hardware versions
change when those component parts are up-
dated or replaced.
10
ACS 561 Service Manual
Robert Bosch GmbH