GLXD4
Wireless Receivers
Transmitters
① Antenna
Carries wireless signal.
② Status LED
LED color and state indicate transmitter status.
③ Power Switch
Turns the transmitter on/off.
④ TA4M Input Jack
Connects to a 4-Pin mini connector (TA4F) microphone or instrument cable.
⑤ Micro USB Charging Port
Connect to USB battery charger.
⑥ Link Button
•
Press and hold within 5 seconds of power-on to manually link with receiver
•
Press momentarily to activate Remote ID function
⑦ Battery Compartment
Holds 1 Shure rechargeable battery.
⑧ Microphone Cartridge
GLXD-2 transmitter models are available with the following cartridge types:
SM58, Beta 58, SM86, Beta 87A.
4
3
1
off on
7
Transmitter Status LED
LED is green during normal operation.
LED color or flashing indicates a change in transmitter status as shown in
the following table:
Color
State
Flashing (slow)
Green
Flashing (fast)
6/19
2
GLXD2
on
5
6
6
7
1
Status
transmitter attempting relink with receiver
unlinked transmitter searching for receiver
Color
Red
Red/Green
Amber
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide a guitar strap through the transmitter clip
as shown.
For best results, the belt should be pressed against the base of the clip.
8
2
3
Wearing the Headworn Microphone
•
Position the headworn microphone 13 mm (1/2 in.) from the corner of
5
your mouth.
•
Position lavalier and headworn microphones so that clothing, jewelry, or
other items do not bump or rub against the microphone.
State
Status
Flashes 3
indicates locked transmitter when power
times
switch is pressed
On
battery life < 1 hour
Flashing
battery life < 30 minutes
Flashing
remote ID active
Flashing
battery error, replace battery
Shure Incorporated
2017/10/23