Connecting Uplink Cable; Connecting The Cable On User Side - Huawei U-SYS IAD208E User Manual

User Manual
U-SYS IAD208E(M) Integrated Access Device Chapter 2 Installing Hardware
The steps for connecting the serial port cable are as follows:
1) Connect female end of the serial port cable to the DB-9 male
connector on the PC or terminal that will configure
IAD208E(M).
2) Connect the DB-9 male connector of the serial port cable to
the configuration port of IAD208E(M).

2.2.3 Connecting Uplink Cable

IAD208E(M) uses a straight-through cable to connect the upper
network device.
The connection steps are as follows:
1) Insert one end of the network cable into the uplink interface
(the RJ-45 interface close to the power interface) on the
back panel of IAD208E(M). Align the strip to the gap on the
interface and insert the RJ-45 connector. If a "click" is heard,
the connector is well plugged.
2) Connect the other end of the network cable to the uplink
network device according to actual situations.

2.2.4 Connecting the Cable on User Side

IAD208E(M) uses a network cable (a straight-through cable or a
cross-over cable) to connect the LAN interface and the splitter.
The connection steps are as follows:
1) Insert one end of the network cable into the downstream
RJ-45 interface on the back panel of IAD208E(M). Align the
Huawei Technologies Proprietary
2-7