Chapter 8: Wireless Compliance
8
Wireless Compliance
Contains FCC ID: 2AQ8D‐RX‐1‐SQVZ
FCC Regulations Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the Interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the factory for help.
Federal Communication Commission (FCC) Radiation Exposure Statement:
The RX‐1 is in compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1‐1999 and has
been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co‐located or
operating in conjunction with any other antenna or transmitter.
28
Formatted: Font: (Default) +Body (Calibri), 11
pt, Not Bold
Formatted: Space After: 10 pt, Line spacing:
Multiple 1.15 li
Formatted: Font: (Default) +Body (Calibri), 11
pt
Formatted: Font: (Default) +Body (Calibri), 11
pt