Advertisement
appropriate experience or knowledge, except when the person is responsible
for their safety Or have previously been instructed to use the equipment.
Children must be supervised to ensure that they do not play with the appli-
ance.
Safely store unused electrical tools. Unused electric tools should be placed in
a dry, elevated or enclosed place, out of the reach of children.
Do not overload your power tool. They work better and safer in the specified
performance range.
Wear appropriate clothing. Do not wear loose clothing or jewelry, they could
be caught by moving parts. When working outdoors, non-slip footwear is rec-
ommended. Apply a hairnet for long hair.
Use protective equipment. Wear protective goggles. Use a breathing mask
when doing dust.
Do not use the cable for purposes for which it is not intended. Do not use the
cable to pull the plug out of the socket or to carry the appliance with it. Protect
the cable from heat, oil and sharp edges.
Pull the plug out of the socket. In case of non-use of the electric tool, before
maintenance and when changing tools, Eg saw blade, drill, milling cutter.
Avoid unintentional start-up. Make sure that the switch is off when inserting the
plug into the wall outlet.
Use extension cables for outdoor use. Use outdoors only approved and appro-
priately marked extension cables.
Be attentive. Pay attention to what you do. Go to work with revenge. Do not
use the power tool when you are un-concentrated.
Check the power tool for possible damage. Before further use of the power
tool, protective devices or slightly damaged parts must be carefully inspected
for their correct and intended function.
Check whether the moving parts work properly and do not jam or parts are
damaged. All parts must be properly assembled and meet all conditions to
ensure proper operation of the power tool. Damaged protective devices and
parts must be repaired or replaced as required by a recognized specialist
workshop unless otherwise specified in the instructions for use. Damaged
switches must be replaced by a skilled electrician. Do not use power tools that
do not turn the switch on and off.
Connect only to sockets with a protective contact. The machine may only be
operated with a max. 10 - 30 mA rated fault current. Observe the specified
mains voltage.
Special safety instructions
Only carry the spiral with the appropriate glove. Do not reuse damaged hands.
When using the glove, it is important to ensure that a latex disposable glove is
worn under the glove for hygienic reasons. (Do not reuse damaged latex
gloves.)
Wear rubber boots (insulation) during cleaning work.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Version 7. 2017
Seite 16
Advertisement
