Risks with repainting There are several risks when disassembling or assembling an Axis product. There is always a certain yield loss during assembly. Training of operators and the use of correct tools mediates some of the problems but they can never be fully avoided. Some of the risks include: ESD Damage - Always handle the product in an ESD safe environment.
Clean the parts properly to remove oil, grease and dust. For more information on the materials used in the product, see its datasheet at www.axis.com Powder coated parts - Use a primer. Alternatively, remove the original powder coating down to the base material, using fine sandpaper, and clean the parts before painting.
Page 4
AXIS Q6215-LE Network Camera How to repaint the product 2. Unscrew the four screws from the main window. 3. Disconnect the heater connector. Note Do not touch the circuit board on the inside of the window.
Page 5
AXIS Q6215-LE Network Camera How to repaint the product 4. Unscrew the four screws from the IR window and remove the IR window. 5. Remove the screws and washers from the foot.
Page 6
AXIS Q6215-LE Network Camera How to repaint the product 6. Remove the SD card cover. Repainting Masking Mask the following parts: • The IR window • The main window • The control button • The screw holes in the foot •...
Page 7
AXIS Q6215-LE Network Camera How to repaint the product Repainting the parts Repaint the camera unit and the SD card cover. Camera unit SD card cover 1. Apply a thin and even layer of spray paint according to the instructions of the paint manufacturer.
Page 8
AXIS Q6215-LE Network Camera How to repaint the product Reassembly 1. Assemble the screws and the washers with the foot. 2. Put the SD card cover back in its place. 3. Connect the heater and assemble the main window. 4. Assemble the IR window.