Table of Contents
Advertisement
2.10.3
SATA/SAS backplane
To remove the SATA/SAS backplane:
1.
Remove the HDD blower case.
Refer to section "2.10.2 HDD
blowers" for instructions.
2.
Disconnect all cables from the
SATA/SAS backplane.
When disconnecting a cable,
hold and firmly pull the cable
plug. DO NOT pull the cable
itself. Doing so may damage the
cable!
3.
Remove the 2 screws on the backplane.
4.
From the inner edge, push the
backplane outward so that the outer
edge protrudes slightly from the
slot.
5.
From the outer edge, firmly hold the
backplane and carefully slide it out.
2-34
Chapter 2: Hardware setup
Advertisement
Table of Contents
