Appendix D - Remote Connectivity - Carrier AquaEdge 19DV Series Start-Up, Operation And Maintenance Instructions Manual

APPENDIX D — REMOTE CONNECTIVITY COMMISSIONING (CONT)
Submittal Data: Fill out all white fields. Scan or photograph
and submit per Customer Gateway instructions.
CHILLER INFORMATION
Parameter Write Values Below
#
PIC6 Software
1.1
Part Number
____________________
Chiller Model
1.2
____________________
Number
1.3 Chiller Serial
____________________
Number
GATEWAY INFORMATION
Parameter
#
Modem Modem serial number e.g. "2017N089911":
information
2.1
Modem S/N: ____________________
STATUS LED
SIGNAL LED Color (per Table B) – (circle one):
2.2
STATE (circle one):
CHILLER CONTROLLER INFORMATION
Parameter
BACnet
3.1
Identifier
_________________________
IP Address
3.2
____.____.____.____
SITE INFORMATION
Parameter
#
Jobsite Name
4.1
_____________________
Jobsite Address
_____________________
4.2
_____________________
Service Office
4.3
_____________________
Service Office
Contact _____________________
4.4
_____________________
_____________________
Table A — Customer Gateway Data Submittal Information
Shown at bottom of start-up screen, or in the menu under Configuration > Control Identifi-
cation. E.g. SCG-SR-20M200400
E.g. 19DV-G4CG4C4425H4-
E.g. 5217Q28248
Value
Seven digits e.g. 1600001 (from Customer Gateway).
This is the IP address with which the PIC6 is configured (from Customer Gateway).
Value
This is the name by which the jobsite is usually recognized. It will be used to distinguish the
site in the monitoring system.
Full address of jobsite. Used to uniquely identify jobsites in case Jobsite Name is dupli-
cated.
Name of service office that services this site.
Name and Telephone Number (or e-mail address).
Description
Write Values Below
RED / YELLOW / GREEN
SOLID / FLASHING
Description
Description
78