Getting Connected - JK Audio innkeeper LTD User Manual

Getting Connected

Connecting to a Single Line Phone
1.
Connect the supplied RJ-11 phone line cable between the jack marked
<Line> and your wall jack. Be sure this jack supports standard single line
analog telephone operation.
2.
You may want to connect an auxiliary telephone to the innkeeper
LTD <Phone> jack so you can dial out and set up calls, or use the
<Auto-Answer> feature to answer incoming calls.
Connecting to a Mixer (Mix Minus Caller)
Note: A mix-minus signal is an audio signal that contains a mix of your local microphones plus
any other audio, minus the Caller's own voice. Sending the Caller's audio back to the innkeeper
LTD will cause an echo, or feedback.
3. Connect the innkeeper LTD <Caller> output to any Line input on the mixer.
4. Connect your microphone(s) to the mic inputs on your mixer.
5. Connect the mixer's Mix-Minus bus or Aux Send output (this may be labeled
FX or Mon but any Aux bus will work) to the <Send> input on innkeeper 1rx.
Set the innkeeper 1rx <Mic/Line> switch to the Line position.
6. If your mixer doesn't have a mix-minus bus: Whichever input channel
you have the <Caller> connected to, turn the corresponding Aux control to
minimum. All Aux controls for other channels should be set for audio sent
to the phone line. Each Aux Send bus is completely separate from all other
outputs, so these Aux controls will not affect what is heard on the Main
outputs or on any other Aux buses.
Tip: Using an Aux Send bus that is Pre-Fader allows you to control the levels of each
channel to the main output without affecting what is sent to the phone line.
7.
Connect your headphones to the mixer.
8.
Use Main Outputs to send audio to recording device or broadcasting
equipment inputs.
4
innkeeper LTD™ Digital Hybrid