Dry Vacuuming - Bissell 5200 User Manual

Dry Vacuuming

With the Dry Vacuum Side of the unit facing
forward, turn the unit on and begin cleaning.
You will see dry dirt, crumbs and debris being
collected in the Dirty Tank. You do not have to
empty the dry debris before Wet Cleaning.
Flipping from Dry to Wet Cleaning
To change from Dry Vacuuming, to Wet Cleaning
simply flip the unit around to the Wet Vacuum side!
The Gentle Clean™ Brush or Pad and Squeegee
will automatically be lowered to effectively clean
and dry all your Hard Floor Surfaces.
Wet Cleaning/Vacuuming
To begin Wet Cleaning, simply pull the Spray
Trigger. Water and Formula will be dispensed
through the Gentle Clean™ Brush or Pad.
To maximize the area to be cleaned, it is
recommended that the Spray Trigger is
squeezed on the forward stroke and released on
the rearward stroke.
CAUTION:
Do not over wet the floor. Apply
Formula by depressing the Spray
Trigger on the forward stroke only
and release the Spray Trigger on
the rearward stroke. Over wetting
the floor surface may cause
delamination of certain laminated
flooring materials.
This will dispense water and Formula going
forward and on the pull back, the Squeegee will
leave the floor essentially dry and ready to walk on.
8
ug603_6719_5200E_305.indd 8 ug603_6719_5200E_305.indd 8
Tip:
To extend the life of your
Filter and to maintain
maximum dry suction,
check the Filter for lint and
debris frequently.
Tip:
To make sure water and
Formula are flowing,
squeeze the Spray Trigger
without the Gentle Clean™
Brush or Pad inserted. You
should see a light stream
of water and Formula
dispensed onto the floor.
11/16/05 2:58:47 PM 11/16/05 2:58:47 PM