Swapping Intelligent Torque Cells - Mecmesin MultiTest–i Series Assembly And Installation Manual

ITC connector

4.3 Swapping intelligent torque cells

You can swap the torque cell by simply disconnecting one cell, removing the crosshead
and then fitting another. First, log out of Emperor and then switch off the stand before
unplugging the torque cell. When the new torque cell has been connected, switch the
stand on again, log on, and after a few seconds the new torque cell will be automatically
recognised. Emperor will read in the new cell's range, serial number and calibration
status.
10  Mecmesin
Assembly and Installation of –i System Test Stands