Troubleshooting (Initial Setup By Manual Setup) - Panasonic KX-HNC810 Information And Troubleshooting Manual

T
roubleshooting (Initial setup by Manual Setup)
Problem
When initial setup The camera's
LED indicator is
is performed
blinking in red�
using Manual
Setup‚ the
following screen
is displayed and
the setup cannot
be completed�
The camera's
LED indicator is lit
in blue�
PNQX8829ZA_M1_ITG_(en)_0208_ver100.pdf 17
Cause Solution
The wireless network Enter the correct password for the wireless
password may be network�
incorrect�
• Unplug the camera and then plug it in again‚
and then try again from the beginning�
The DHCP function Confi rm that the wireless router's DHCP settings
of your wireless are enabled� Refer to your wireless router's
router may be manual�
disabled�
• Unplug the camera and then plug it in again‚
and then try again from the beginning�
Your mobile device Connect your mobile device to the same wireless
is connected to network that was used to set up the camera and
another network� try to add the mobile device again�
A network clash has Unplug all the wireless routers and plug them in
occurred because again�
you have 2 wireless
If the situation still does not improve‚ refer to your
routers at home
wireless router's manual for information on how
that are using the
to change the router channel of your wireless
same channel or
network�
channels of a close
frequency�
17
2019/02/08 19:44:18