Pgcsim; Installing Pgcsim; Optimizing The Memory; Checking Of Memory Assignments - Siemens PGC 302 Edition II Manual

PGCSIM: Simulation of chromatographs

PGCSIM

The operating software for the chromatographs
previously only functioned if a chromatograph was
connected to the control unit.
software package and simulates a chromatograph
in the control unit. It is then possible, without a
connected chromatograph, to:
Evaluate and reintegrate runs which have been ex-
ecuted e.g. during the night
Generate and optimize methods
Demonstrate the operating software
Practice operation.

Installing PGCSIM

Insert the
PGCSIM
a:
install
The installation generates the file SIM.BAT.

Optimizing the memory

In certain operation situations, the operating software
requires almost the complete main memory of 640 kB.
To ensure that the operating software is executed cor-
rectly, no TSR programs must be loaded in the main
memory. Other TSR programs and a number of pro-
grams belonging to the operating software can be
loaded into the upper memory.
If you wish to learn more on the memory in the control
unit, refer to your MS-DOS manual or ask our servic-
ing department. The following points are important in
this context:
The file
CONFIG.SYS
The device drivers
and their parameter settings
The commands
for uploading programs
The file
AUTOEXEC.BAT
The command
LH
You should upload the following programs of the simu-
lation software:
LPRINT/CPRINT
PGCSIM (this is the largest)
SIMRES
PGCSIM: Simulation of chromatographs
14
is a separate
PGCSIM
diskette into the drive a: and type in:
RETURN
RETURN
and
HIMEM.SYS EMM386.EXE
and
DOS=HIGH,UMB DEVICEHIGH
for uploading programs
Checking the memory assignments
The current memory assignments of your control unit
are indicated by the
DOS
following command following the
mem /c |more
Please observe the vertical line (ASCII 124) in front of
more!
The file SIM.BAT
The file is regenerated when you install
SIM.BAT
. If you have modified
PGCSIM
sion, you must enter these modifications again in the
new . Use the
SIM.BAT MS-DOS
The commands in
SIM.BAT
The file appears as follows after installation:
SIM.BAT
PGCSIM T2
INITCHRO 1 0
IF ERRORLEVEL 1 GOTO EXIT
SIMRES
CD C:\BEDI
REM LPRINT c500
CALL SWITCH
:EXIT

The meaning of the program names

TSR
PGCSIM
chromatograph and communicates
with the
Corresponds to ChromLAN.
T2 = Process
T3 = Laboratory
T3 A = Laboratory with autosampler
Normally
INITCHRO
chromatographs are connected to the
control unit. It defines this during the
simulation.
TSR program,
SIMRES
printing processes
TSR program for printing of results,
LPRINT
chromatogram and
Produces
LAN
network summary
Produces
SWITCH
operation

Starting the simulation

Select the directory bedi, and type in
RETURN
sim
The operating software is started as usual.
command . Type in the
MEM
prompt:
DOS
in an old ver-
SIM.BAT
editor to do this.
program, simulates the
operating functions.
checks how many
coordinates e.g.
texts
BASIC
colored displays
colored displays
5PGCSIM.CHP, Stand Dezember 22, 1999
for
for