System Card; Communication Terminals; Technical Support - Emerson Rosemount 375 Getting Started

8
S
TARTING THE
1. On the keypad, press and hold the On/Off key until the multifunction LED blinks
(approximately two seconds). During start up, the 375 Field Communicator checks
the System Card for any software upgrades and notifies you if an upgrade is
required. Then, the 375 Main Menu displays.
2. From the 375 Main Menu, use the up and down arrow keys to select menu items
and the right-arrow key to launch them. Settings and system information are
available in the Settings menu. For details, see the latest version of the 375 Field
Communicator User's Manual.
R
EMOVING THE BATTERY AND
1. With the 375 Field Communicator off, place it face down on a level, secure surface.
2. Loosen the two battery retaining screws until the top of each screw is flush with the
top of the 375 Field Communicator.
3. Slide the battery off the communicator.
CAUTION
Do not pull up on the battery as this could damage the connector pins.
4. Grasp the System Card tag and slide it straight out of the 375 Field Communicator.
CAUTION
Do not pull up on the System Card as this could damage the card or the System
Socket.
C
OMMUNICATION TERMINALS
The access door on the top of the 375 Field Communicator can be put in two positions.
Use the markings on the access door and in between the terminals to select the
desired protocol. Use the provided leadset to connect the 375 Field Communicator to
the loop or segment. Refer to the latest version of the 375 Field Communicator User's
Manual for additional information.
CAUTION
Only connections to a HART loop and F
T
ECHNICAL SUPPORT
Contact your supplier or go to http://www.fieldcommunicator.com/supp.htm for
technical support contact information.
375 F
IELD
OUNDATION
Starting the 375 Field Communicator
C
OMMUNICATOR
S
YSTEM
fieldbus segment are allowed.
C
ARD