Getting Started; Connecting Your Platformnano Controller - ICON PlatformNano User Manual

Getting Started

Connecting Your PlatformNano Controller

3
1 Connect the PlatformNano to your Mac/PC via the USB port

Choose a USB port on your Mac/PC and insert the wide (flat) end of the USB

cable. Connect the cable's other end to the PlatformNano. Your Mac/PC should

automatically "detect" the new hardware and notify you that it is ready to use.
1. Select the DAW at PlatformNano.
2

Press <</>> to scroll through the DAW mode list and then press the "DAW mode"
button to make the selection.

Tip: PlatformNano will memorize your last selected DAW mode and re-enter the
same mode a few seconds after it the unit has been switched powered on. (i. e.
DAW mode selection is not needed necessary if the last DAW mode is being used. )


3

Setup your DAW

Activate the ICON PlatformNano controller in your DAW or MIDI software using "MIDI
Setup" or "MIDI Devices".

Select MCP for Nuendo/Cubase, Digital Performer, FL Studio, SamplitudePro, Reaper, Studio
One, Bitwig, Reasons, Audition, Sonar, Ableton Live, Digital Performer select Mackie Control.

Select HUI for Pro Tools.

Select Logic Pro for Logic Pro.

(Note: Every application does this a little differently, so refer to your software user
manual for the settings. )


2
(1)
MCP
(1)
Nuendo/Cubase; Digital Performer; FL Studio; SamplitudePro;
MCP
Reaper; Studio One; Bitwig; Reasons; Sonar; Audition; Ableton Live
(2)
Logic Pro
LogicPro
(3)
ProTools
HUI
(4)
User self mapping with iMap
User-Def
1
Tab
CapsLook
Shift
Ctrl Alt AltGr Ctrl
intel
9