Return-To-Up Spring Adjustment - Exmark ARX440CKC24000 Operator's Manual

1. Adjustment rod
6. Looking down towards the adjustment rod —
rotate it counterclockwise, in 1/4 turn increments,
to increase speed or clockwise to decrease speed.
7. Drive the machine and check the full forward
tracking.
8. Repeat steps 5 through 7 until desired tracking
is obtained.
Return-to-Up Spring
Adjustment
WARNING
Springs have stored energy. Overtightening the
springs may cause the springs to fail which can
cause serious injury or death and damage to the
machine and property.
Make sure springs are properly adjusted and/or
replaced as specified in the Operator's manual.
Check the gap between the spring bracket and the
end of the spring as shown in Figure 21. The gap
should measure 1.38 inch (35 mm). Adjustment is
made by turning the bolt at the front of each spring
(clockwise will shorten the gap, counter-clockwise
will lengthen the gap).
Figure 20
g233418
1. 1.38 inch (35 mm)
Important: The springs must be replaced it the
gap is less than 1.13 inches (29 mm).
Always replace both return-to-up springs. This
prevents uneven loading and possible damage to
the machine.
37
Maintenance
Figure 21
g233568