Western Telematic WTI NBB-20VS20 Series Hardware Manual page 3

Two Power Supply Cables
Note that some NBB series units feature two separate power inlets and a separate
power supply cable for each power inlet. Make certain to disconnect all power supply
cables from their power source before attempting to service or remove the unit.
15 Amp Starter Cable(s)
If the NBB unit includes a detached, 125 VAC, 15 Amp "Starter" Cable(s,) this allows
you to connect the NBB to power for bench testing and initial start up is adequate for
applications that only require 15 Amps. For 20-Amp power switching applications,
please refer to the WTI Power Cable guide, or use appropriate 20-Amp cables.
Units with Attached Power Supply Cable(s)
For units with fixed power cords, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
ii
Warnings and Cautions