Mounting Plates; C.2. Mounting Plates - Western Telematic WTI NBB-20VS20 Series Hardware Manual

C.2. Mounting Plates

The flat Mounting Plates included with the unit, can be used to mount NBB units in most
standard equipment racks. When the Mounting Plates are used, NBB units can be
mounted facing either side of the rack.
1. Attaching the Brackets to the NBB: Determine which direction the NBB will face
after mounting, and then secure the Mounting plates to the NBB as shown in
Figure C.4, using the screws provided with the mounting brackets.
The Mounting Plates can either be attached to the back or side of the unit, and the
unit can also be installed to face the front, rear, or either side of the equipment rack.
2. Attaching the Mounting Plates to the Equipment Rack: Determine which
direction the NBB unit will face in the rack, then line the screw holes in the Mounting
Plates up with two holes in the equipment rack mounting strip. Make certain that
the unit is level, and then use two screws to secure each Mounting Plate to the rack
as shown in Figure C.4.
Mounting
Plate
Figure C.4: Installing Mounting Plates
Rear Panel
Mounting
Apx-5
Front Panel
Plate
Appendices