Table of Contents
Advertisement
Appendix C.
The NBB offers a variety of different mounting options that allow the unit to be easily
mounted in most common equipment racks. In addition to the mounting buttons and
flat mounting plates included with the NBB unit, optional mounting brackets are also
available.
C.1. Mounting Buttons
The Mounting Buttons allow NBB units to be mounted in any equipment rack that
includes mounting button holes. Depending on the location of the mounting button
holes, this allows the NBB to be mounted on the posts at the rear of the equipment rack,
or in some cases, mounted on the outside of the rack corner posts.
1.
Determine the Appropriate Mounting Button Locations: Refer to Figure C.1 and
the table below to determine the appropriate button locations for your individual
equipment rack:
Rack Type
APC, SMC, Wright Line
Standard Mounting Locations
Mounting
Button
Figure C.1: Installing Mounting Buttons
Rack Mounting Instructions
A1
A2
STD-1
STD-2
Rear Panel
Mounting
Button
Distance Between
Buttons (Center)
49"
36.75"
Front Panel
A1
STD-1
STD-2
Apx-3
Button Holes Used
A1 and A1 (or)
A2 and A2
STD-1 and STD-1 (or)
STD-2 and STD-2
A2
Advertisement
Table of Contents
