Table of Contents
Advertisement
2.2.
Additional Button Functions
The Default and Reset buttons on the NBB front panel can be used to perform the
functions described below:
• All Front Panel Button functions can also be disabled via the System
Parameters menu, as described in the WTI Firmware Guide.
• When the NBB is reset to factory defaults, all user-defined configuration
parameters will be cleared, and the default "super" user account will also
be restored.
1.
Reboot Operating System:
a)
Press and hold the Reset button for five seconds, and then release it.
b)
The NBB will reboot it's operating system; all plugs will be left in their current
On/Off state.
2.
Set Parameters to Factory Defaults:
a)
Simultaneously press both the Default button and the Reset button, hold them
for five seconds, and then release them.
b)
All NBB parameters will be reset to their original factory default settings, and
the unit will then reboot. All plugs will be left in their current On/Off state.
3.
Toggle/Default All Plugs:
a)
Press the Default button, hold it for five seconds, and then release the Default
Button.
b)
The NBB will switch all plugs to the Off state. If all plugs are already in the Off
state, then the unit will reset all plugs to their user defined default states.
Notes:
2-4
Unit Description
Advertisement
Table of Contents
