Western Telematic WTI NBB-20VS20 Series Hardware Manual page 19

2. Install two Mounting Buttons in the holes selected in Step 1 above. Refer to
Figure C.2 below for further details regarding assembling the Mounting Buttons and
attaching them to the NBB unit.
3. Refer to Figure C.3 below to make certain that the equipment rack includes
appropriate mounting button holes and then attach the NBB unit to the rack by
inserting the Mounting Buttons into the Mounting Button holes. When the NBB
is in place, slide the unit downward to securely seat each Mounting Button in its
corresponding hole.
Retaining Screw
Screw Hole on
NBB Rear Panel
Figure C.2: Attaching Mounting Buttons to the NBB Unit
Figure C.3: Mounting Button Hole Specs
Mounting Button
Approx. 3/4 Inch
Approx. 3/8 Inch
Apx-4
Appendices