Phone Connection - Sony PCWA-C100 Operating Instructions Manual

Note
If you must press "0" on
your telephone to hear
the tone signal and place
an outgoing call, you can
not use your telephone
line for Internet access
using the Access Point.
If you hear the tone signal
when you pick up the
receiver even though you
must press "0" to place an
outgoing call, you can use
your telephone line for
Internet access using the
Access Point. In these
situations, enter "0"
before the telephone
number for Phone
Number 1 and Phone
Number 2.
z Tips
• Phone Number 2 is the
alternate telephone
number to use when a
call to Phone Number 1
is not completed.
• Your Internet Service
Provider may specify
the DNS server(s). In
this case, enter data for
DNS Server 1 (DNS
Server 2).
Note
The indicators on the
Access Point flashes while
changes to the settings are
processed.
The link test is disabled
until the Access Point
POWER indicator turns
green.
(It takes approximately 30
seconds before the
POWER indicator turns
green.)

Phone Connection:

The Enter Phone Connection Parameters dialog box
appears.
1
Enter data for Account ID, Password, Password
(re-enter), Phone Number 1, Phone Number 2, and
Dialing Mode and click NEXT.
The confirmation dialog appears.
2
Make sure you have made correct settings, then
click NEXT.
Changes to the Access Point settings are reflected
and the Finish screen appears.
3
Click LINK TEST.
The link test between the Access Point and the
computer is performed.
When the confirmation dialog box appears, click
FINISH to exit.
51