Installing And Connecting The Isyteq Touch Control Panel - Iloxair ILOX 129 Installation, Operation And Maintenance Manual

18
CONTROL PANEL ISYteq TOUCH 3.5 - INSTALLATION AND CONNECTION
1. Open the control panel using a screwdriver.
2. Lift the display out of the enclosure.
3. Push the connection cable through a suitable hole and if needed
make an outlet for the cable on side of the cover.
FläktGroup DC_10201GB_20190207_R2
Heat Recovery Unit ILOX 129 - Installation, Operation and Maintenance
4. Mount the enclosure directly on the wall or using the screws in a
junction box.
5. Connect the cable to the back of the display as shown above. NOTE!
Do not touch the electronics.
6. Push the display back into the enclosure.
ISYteq Touch 3.5
1 N
2 L
3 N
4 L
5 N
6 L
7 N
8 L
11 N
12 L
13 14 15 16
7. Check that the control cable is correctly connected to the con-
trol card before switching on the power supply.
70 69 68 67 66 65 64
51
50
USB
49
A
48
47
Ethernet card
Ethernetkort 46
(accessory)
(tillbehör)
B
27 28 32 33 34 35 36 37 38
We reserve the right to make changes without prior notice