Removing The Rear Panel; Removing The Shield Cover - JVC RX-DP10VBK Service Manual

RX-DP10VBK/RX-DP10VSL
RX-DP10RSL

Removing the rear panel

Prior to performing the following procedure, remove
the top cover.
1. Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2. Remove the thirty six (B/E/EN version is thirty two)
screws E attaching the each boards to the rear panel
on the back of the body.
3. Remove the thirteen screws F attaching the rear
panel on the back of the body and bottom.
Removing the system control board
Prior to performing the following procedure, remove
the top cover and front panel assembly.
1. Disconnect the card wires and harness from
connector CN963, CN964 and CN981 on the system
control board.
2. Cut off the tie bands fixing the harnesses.
3. Disconnect the harness from connector CN43 on the
power supply 2 board and CN25 on the power/ fuse
board.
4. Disconnect the connector CN324 on the audio signal
2 board and CN205, CN234, CN208(J/C only) on the
audio signal 1 board.
5. Remove the three plastic rivet.
Removing the DSP board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Disconnect the connector CN631 on the DSP board.
2. Disconnect the connector CN203 on the audio signal
1 board.
3. Removing the two plastic rivet and disconnect the
connector CN633 on the DSP board.

Removing the shield cover

Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Removing the screw G attaching the shield cover.
2. Shift the shield cover before, and pull upward.
1-6
(See Fig.4)
Power/ fuse
(See Fig.5 and 6)
board
Tie band
Power supply 2 board
(See Fig.6 and 7)
(See Fig.8)
CN983
CN977
CN981
System control board
Plastic rivet
CN985
Fig.5
CN25
Audio signal 1 board
Audio signal 2 board
CN43
Fig.6
Plastic rivet
CN633
Fig.7
G
Shield cover
Fig.8
Plastic rivet
CN963
CN971
CN964
CN324
Tie band
CN203
Tie band
CN208
(J/C only)
Tie band
CN234
CN205
Tie band
CN631
Plastic rivet
DSP board