Hach AV9000S User Manual page 14

With submerged area/velocity sensor.

Table of Contents

Available languages

Figure 8 Avoiding silt when mounting the sensor

1 Water

2 Pipe

Operation

For sensors connected to an FL900 flow logger, connect a computer with

to the flow logger to configure, calibrate and collect data from the sensors. Refer to the

Desktop documentation to configure, calibrate and collect data from the sensor.

For sensors connected to an FL1500 flow logger, refer to the FL1500 flow logger documentation to

configure, calibrate and collect data from the sensors. As an alternative, connect a computer with

DATA Desktop software to the flow logger to configure, calibrate and collect data from the

sensors. Refer to the

the sensor.

For sensors connected to an AS950 sampler, refer to the AS950 sampler documentation to

configure, calibrate and collect data from the sensors.

For sensors connected to a Sigma 910, 911, 920, 930 or 940 flow meter, connect a computer with

InSight software to the Sigma flow meter to configure, calibrate and collect data from the sensors.

Install the software

Make sure that the latest version of the

the computer as applicable. Download the software from http://www.hachflow.com. Click Support,

then select Software Downloads.

Configure the sensor

For sensors connected to an FL900 flow logger, configure the sensors with the

Setup Wizard. Refer to the

14 English

DATA Desktop documentation to configure, calibrate and collect data from

DATA Desktop software or InSight software is installed on

DATA Desktop documentation for instructions.

3 Sensor

4 Silt

DATA Desktop software

DATA

DATA Desktop

Table of Contents

Av9000