Nilfisk-Advance Advolution 2710 Manual

Advolution 2710 Rider Burnisher How To
1
Before burnishing: Pre-
sweep or scrub floor area
to prevent scratching.
4
Lift and lock deck to
inspect burnishing pad
for wear.
7
Verify dust collection
bag is installed.
10
Adjust seat if needed.
Prepare for use
2
Onboard charger:
Disconnect battery
Store cord inside
machine frame.
5
Turn pad retainer
counter clockwise to
remove the pad.
8
Store additional dust
collection bags here.
11
Turn on machine. Verify
battery power.
3
Shelf charger:
disconnect then
connect machine to
batteries.
6
Install new pad and
center on outside
diameter. Tighten pad
retainer clockwise.
9
Adjust steering wheel –
tilt to comfort.
12
Use motion control
pedal for forward and
reverse. Transport
machine to work area.