Table of Contents
Advertisement
Software
6.1.2 Registering a new board
IMPORTANT!
i
To register a new board, you must have administrator rights. Only an
administrator is allowed to register a new board or change a registration.
♦ Call up the ADDIREG program.
The Fig. 6-1 is displayed on the screen.
♦ Click on "Insert". Select the wished board.
♦ Click on "OK".
The default address, interrupt and the other parameters are automatically set
in the lower fields. The parameters are listed in the lower fields. If the
parameters are not automatically set by the BIOS, you can change these
parameters. Click on the wished scroll function(s) and choose a new value.
♦ Activate your selection with click.
♦ Once the wished configuration is set, click on "Set".
♦ Save the configuration with "Save".
You can test if the registration is "OK".
This test controls if the registration is right and if the board is present.
If the test has been successfully completed you can quit the ADDIREG
program.
The board is initialised with the set parameters and can now be operated. In
case the registration data is to be modified, it is necessary to boot your PC
again.
A message asks you to do so. When it is not necessary you can quit the
ADDIREG program and directly begin with your application.
6.1.3 Changing the registration of a board
IMPORTANT!
i
To register a new board, you must have administrator rights. Only an
administrator is allowed to register a new board or change a registration.
♦ Call up the ADDIREG program.
♦ Select the board to be changed.
The board parameters (Base address, DMA channel, ..) are listed in the
lower fields.
28
APCI-7xxx
Advertisement
Table of Contents
