Yaesu FT-736R Operating Manual page 12

VOX = voice-actuated transmission (or
semi break-in CW)
PROC = speech processor on
KEYER = CW keyer on
BURST = auto-burst activated
(23) ON AIR and BUSY LEDs
The red ON AIR indicator giows while
transmitting. The green BUSY indicator
giows when the squelch is open while re-
ceiving, and is used for adjusting SSB and
FM microphone gain (deviation) when
transmitting.
(24) METER Selector and Meter
mc rAn
st po
Ate 04 ( i ir igin
1 3 3 !
P0
ut
The meter indicates either relative recei-
ved signal strength (S scale, top) or FM
discriminator center tuning (DISC scale,
bottom) while receiving; and relative
transmitter power output (P0 scale), or
transmitter automatie level control (ALC
scale) while transmitting. The METER
selector determines the meter function
according to operating mode:
ALC, PO and S (the three leftmost post-
dons) select the meter functions during
satellite (full duplex) operation only.
tas 1331213 1:1 El OM
F M V FO A
US U N VFO R
1
IS
LSO
C Kr N CALL
S/PO and DISC/ALC are for simplex and
semi-duplex operation. The S/PO
selection shows received signal strength
and transmitter power output in all
modes. The DISC/ALC selection, while
receiving, also shows S-units in SSB and
CW modes, but in the FM mode the
meter indicates discriminator center
tuning. While transmitting with the
DISC/ALC selection, the meter shows
ALC (automatie level control voltage) in
SSB and CW modes, and relative power
output in PM.
(25) PREAMP Button
This button switches +I3V DC (max 300
mA) at the ANT jacks during reception, to
control a masthead preampli fier (not
supplied).
(26) Small Controls
VOX
x va
MAIN OCLAV ~WIM. uPta0
r 1 / 2 54- t hir '
4,1
J' 41
Oor
VOX GAIN, DELAY & ANTI-TRIP
These controls set the automatie voice-
actuated transmit/receive switching in
SSB and FM modes; and semi break-in
keying in CW mode. Adjustment details
are in the Operation chapter.
I
PRI PMS
A SV s TEM
One H ENC
nap
Lj Lj
otc oma
I1