Table of Contents
Advertisement
Programming
NOTE: When retracting or extending, the switch will need to be depressed and held for 2 seconds after the
room stops moving. Failure to do so will cause the stops to NOT be set.
Setting the Retracted Stop Point
1.
Press and hold the IN button on the wall rocker switch (Fig. 8B).
Move the room to the fully retracted position. Press and hold the IN button for 2 seconds after the
2.
room stops moving. Release the wall switch.
Visually inspect the room seal to make certain the room is fully retracted. If it is not, push and hold the
3.
IN button until fully retracted. This procedure may need to be repeated until both sides of the slide-
out are fully retracted.
Setting the Extended Stop Point
Press and hold the OUT button on the wall rocker switch (Fig. 8A).
1.
2.
Move the room to the fully extended position. Press and hold the OUT switch for 2 seconds after the
room stops moving. Release the wall switch.
3.
Visually inspect the room seal to make certain the room is fully extended. If it is not, push and hold the
OUT button until fully extended. This procedure may need to be repeated until both sides of the slide-
out are fully extended.
Installation Issues
The control box is equipped to help troubleshoot the system during installation. Count the number of LED
flashes and refer to the FAULT DIAGNOSTICS/TROUBLESHOOTING section starting on page 8 of this manual
or on the label of the control box.
NOTE: It is important that the slide-out motors be plugged in to the proper receptacle at the control box.
See Fig. 7 for proper slide-out motor designation. Failure to properly connect the motors to the
control will result in problems for future troubleshooting. (The control will identify the incorrect
motor during a fault).
If you are still having difficulties programming the system (and prior to replacing the control), verify that
the system has been wired correctly and that the IN stop location was programmed before the OUT stop
location. See Fig. 7, page 5 for proper connection of the motors to the slide-out control.
Rev: 05.24.2016
Always make sure that the slide-out room path is clear of people and objects
before and during operation of the slide-out room. Always keep away from the
slide rails when the room is being operated. The gear assembly may pinch or
catch on loose clothing causing personal injury.
A
Fig. 8
B
Page 6
Slim Rack Slide-out Manual
Hide quick links:
Advertisement
Table of Contents
