Table of Contents
Advertisement
Appendix A: Communication and Control Troubleshooting Tips
Pilot Lite Does Not Find All Modules in Frame
+
60
A legacy 6800 series product is in the frame. + Pilot Lite cannot
•
communicate with legacy 6800 series products. They will not be
discovered or controlled by + Pilot Lite, although they can be
installed in the FR6802+ frame and work using card edge controls.
The module must be from the 6800+ product family.
•
Check that the back module does not have any bent pins. Follow
this procedure:
a. Unplug the front module first
b. Unscrew and remove the back module.
c. View the 30-pin spring connector at the bottom of the back
module. See
Figure
Figure A-1. Connector on 6800+ Back Module
This connector should not have any bent or pressed pins. Even
a slightly depressed or bent pin may cause genlock issues.
d. If there are bent pins, carefully re-position them to their correct
positions.
If this is not possible, a back module can be obtained from the
manufacturer.
If a discovery is started too soon after frame power-up, + Pilot Lite will
not find all the installed modules. Refresh + Pilot Lite (File >
Refresh), and ensure that installed modules are fully powered-up first
before discovery.
A-1.
30-pin
connector
HUC6800+ Installation and Operation Manual
Advertisement
Table of Contents
