Table of Contents
Advertisement
Software Communication and Control Issues
Pilot Lite Fails to Communicate with Installed Modules
+
HUC6800+ Installation and Operation Manual
Appendix A: Communication and Control Troubleshooting Tips
•
"+ Pilot Lite Fails to Communicate with Installed Modules" on
page 59
•
"+ Pilot Lite Does Not Find All Modules in Frame" on page 60
•
"+ Pilot Lite or CCS Software Application Not Responding" on
page 61
•
"+ Pilot Lite Cannot Control a Module Showing
in the Control Window" on page 61
•
"+ Pilot Lite Status Bar Reports 'Not Ready'" on page 61
•
"CCS Software Application or Remote Control Panel Does Not
Communicate with Module" on page 62
•
"Alarm Query Fails When a Device Reboots" on page 62
Confirm that the following items are not the reason for the
communication failure:
•
Proper module slot has not been specified (+ Pilot Lite is not
communicating with the appropriate slot). See your FR6802+
Frame Installation and Operation Manual for more information on
slot identification.
•
COM port is used elsewhere (Check that the correct COM port is
configured in + Pilot Lite and that another application is not using
that COM port).
•
Actual frame ID does not match with the two DIP switch settings in
the back of the frame (+ Pilot Lite is not communicating with the
proper frame). See your FR6802+ Frame Installation and
Operation Manual for more information on frame ID switch
settings.
•
Null modem cable is not being used. Between the PC running
+ Pilot Lite and the FR6802+ frame, there should be a null RS-232
modem cable. At minimum, this requires that pins 2 and 3 are
crossed and 5 to 5 for ground.
•
ICE6800+ module is installed in the frame (+ Pilot Lite control is
disabled if an ICE6800+ module is installed in the frame;
ICE6800+ modules are used for CCS control).
59
Advertisement
Table of Contents
