Table of Contents
Advertisement
Chapter 3: Operation
Control Parameters
Note
The sequence of options listed
in the Options column mirrors
the sequence achieved when
you move the Navigation
Toggle switch up.
Table 3-5. Control Parameters
Bank,
Rotary
Parameter Name
Switch
X
Bank Select
Bank 0
0, 1
Output Video Standard
0, 2
On Screen Display
0, 3
OSD Transparency
0, 4
Input Video Standard
36
The following table lists all of the available parameters and options for
the HUC6800+ and HUC6800+C. All parameters clip unless
otherwise indicated.
The On/Off combinations of the control LEDs on the card-edge indicate
the active bank number. See
for more information.
Legend
Bold option = Indicates that this is the default setting for the parameter
[RO] = Indicates that parameters are read-only/feedback, and cannot be
used to select controls
* = Indicates that this parameter wraps when controlled from the
card edge
Function
Selects the active bank number
Selects the SDI output video signal
standard (only the applicable options are
displayed in the OSD)
Turns on/off the on-screen display
Sets the on-screen display transparency
level
Selects the SDI input video signal standard
(Note: If you select a non-synchronous
standard, the OSC will disappear; if this
occurs, use the LEDs to find Factory
Recall and then regain use of the OSD.
This will take several seconds.)
"Changing Parameter Settings" on page 33
Options
0 to 5
• 720p59.94
• 1080i59.94
• 720p50
• 1080i50
• Off
• On
0 to 15
• Auto
• 525
• 625
HUC6800+ Installation and Operation Manual
Advertisement
Table of Contents
