Externally Mounting Gas Tank - Marvel ML24BN Series Installation, Operation And Maintenance Instructions

Optional gas tank external mounting bracket:
The optional mounting bracket is designed to hold the 5#
gas cylinder that comes with the beer dispenser. Larger
cylinders may be purchased from a third party and mounted
externally. Use the hole port on the rear of the cabinet to
run the gas line to the keg.
Many options are available for mounting the gas tank
outside of the beer dispenser to gain additional cold
storage space inside.
Secure the optional external mounting bracket on the
back of the beer dispenser (this is ideal for mobile
units) or mount within adjacent cabinetry (ideal for
undercounter built-in units:
Mount the (4) screws (#10-32 x
screws) provided with the bracket in the rear of the
appliance, see Figure 43. Do not completely tighten. Place
the keyhole slots in the flanges of the bracket over the
four screws and tighten them to secure the bracket to the
back of the cabinet. The bracket can also be fastened
to adjacent cabinetry using the provided #10 x
screws.
Mark the hole locations where required using a pencil and
the slots in the mounting bracket. Drill appropriate pilot
holes (depending on the material you are mounting to) and
secure the bracket per the above instructions.
NOTE
The foam insulation plugs provided in the portholes are
CRITICAL to proper functioning of the unit and preventing
frost build up that can cause damage to the unit and/or
refrigerator contents. ALWAYS reseal the gas line porthole
(Figure 43) with the provided insulation plugs once all lines
have been properly installed.
NOTE
Consider the length of the red air line when choosing a
place for the gas tank. The red air line supplied is 4 feet
(1.2 meters) long.
With the gauges mounted to the gas tank place the tank in
the mounting bracket.
Remove the foam plug from the hole port as shown in Fig-
ure 46, and feed the red gas line through the rear wall and
out the coil cover on the inside of the cabinet. Connect the
red gas line to the keg coupler.
Reseal the hole in the back of the cabinet with the foam
plug. See Figure 47.
USING YOUR BEVERAGE DISPENSER
⁄ " flathead machine
3
4
⁄ " wood
3
4
CAUTION
!
If the gas tank is placed on the floor it must be secured in
the upright position with a chain or other means to prevent
it from being tipped over.
Remove foam plug
from hole port
Mounting
bracket
Reseal hole
around tubing with
the foam plug
22
Screws (4)
Figure 43
Gas tank
placed in the
bracket
Figure 44