Marvel ML24BN Series Installation, Operation And Maintenance Instructions page 14

Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door, remove the magnetic door gasket from
the interior side of the door, see Figure 16. Set the gasket
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack.
Holes in
gasket
retainer.
Figure 16a
Figure 16
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 14 and 15 for a left hand door
model or Figures 16 and 17 for a right hand door model.
OVERLAY DOOR PANEL INSTALLATION
Overlay panel
flush with top
of door.
Overlay panel to
be centered on
width of door.
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.
14