Chapter 2 Installation; Change Direction Of Swing Door - Gamko FLEXBAR X/2 Series User Manual

Tip! Select the opening direction before installing the segment.
1 Open the door and remove the cover cap at the top of the frame. Do so by placing a screw driver's flat head
into the holes underneath and gently twist.
2 Close the door and remove the upper hinge by loosening the 2 screws.
3 Remove the door by lifting it carefully away from the lower hinge.
4 Remove the lower hinge by loosening the 2 screws.
5 Fit the hinge from step 2 at the other lower side (diagonally opposite).
6 Remove the hand grip and trim strip by partially removing the magnetic frame and the screws and
attachment strip this conceals.
7 Fit the trim strip, attachment strip and hand grip to the hinge position on the other side, using the 4
screws.
8 Press the magnetic frame back into its original position.
9 Replace the door and fit the upper hinge cover cap using the 2 screws (i.e. the hinge which you removed in
step 4).
10 Place the cover back on. Slide the cover backwards (never downwards).
cover
attachment
strip
screw
Chapter 2 Installation
Altering the opening direction
magnetic gasket
screw
trim strip
hinge
31