Valeo ClimFill Maxi Use And Maintenance Manual page 7

ClimFill Maxi
WORKPLACE: The equipment must be operated outdoor or in a well-ventilated location
(at least 1 air change per hour). The workshop has to be equipped with ventilation
systems able to ensure air change in every environment area or carry out a periodical
ventilation by opening the areas. Use the equipment away from heat sources or hot
surfaces . The equipment must not be used in explosion risk environments (potentially
explosive atmospheres). Before using it, put the equipment on a levelled plane and
secure position, blocking it with suitable wheel stops.
Do not expose the tool to direct sunrays, heat sources, rain and jets of water. Do not
smoke close to the equipment and during operations (keep at a distance of at least 1
m).
The work area must be monitored by the operator while the equipment is operating.
ATTENTION: the R134a refrigerant fumes/gases are heavier than air and can gather on
the floor or inside cavities/holes and cause choke by reducing the oxygen available for
breathing.
At high temperatures, the refrigerant breaks down releasing toxic and aggressive
substances, harmful for the operator and the environment.) Avoid inhaling the system
coolants and oils. Exposure can irritate eyes and the respiratory tract.
ELECTRICAL CONNECTION: Connect the power cord solely to a mains supply which
conforms with the ratings on the machine's nameplate (mounted on its side). Make sure
the mains socket is grounded.
Maximum impedance allowed in the point of connection to the mains shall comply
with standard EN 61000-3-11. Starting currents can cause short voltage drops, which
may affect other equipments under unfavourable conditions. If impedance in the point
of connection to the mains is not compliant, this may lead to interference so please
consult the electrical power network operator before connecting the equipment.
Never use the service station with a defective power cord or a different one from that
supplied with the machine. If damaged, immediately have it replaced with an original
spare part or equivalent by a VALEO SERVICE centre. Before opening the service
station, extract completely the supply cable from the plug, or you can get an electric
shock.
Do not tamper with or bypass the safety equipment and settings.
Do not leave the machine powered up when not in use; shut off the power supply
before leaving the equipment unused for a long time. Do not forget that the tool
(pressure tool) must always be protected.
ENGLISH 7 / 74 CAP. 3 - SAFETY CONDITIONS