Marlec Solar iBoost+ Installation Instructions

Hide thumbs Also See for Solar iBoost+:

Enlarged version

Installation Instructions

(Installation by Qualified Electricians Only)

Doc. No: SM-504 Iss B 01.07.19

Table of Contents

Need help?

Do you have a question about the Solar iBoost+ and is the answer not in the manual?

Page 1 Installation Instructions (Installation by Qualified Electricians Only) Doc. No: SM-504 Iss B 01.07.19...
Page 2 General Scheme Layout Checks Before Commencing Installation Check you have received the following:  Solar iBoost+ main unit (A)  Measurement Clamp (B)  Sender (connects to measurement clamp) (C) Generation Utility Meter Meter  2 × AA batteries (for Sender) Consumer ...
Page 3: Installation
Installation Wiring Diagram For all installations - Positioning - Use the installation template provided  Test the immersion heaters and thermostats before installation and replace defective parts where Locate the Solar iBoost+ close to the hot water tank and connect electrically between a fused outlet or MCB necessary.
Page 4: Operation
Commission and Test the System Assembling the Sender and Measurement Clamp These tests are designed to verify that only excess generation is used by the Solar iBoost+. Installers The Sender unit has a Measurement Clamp that detects export current when fitted around the must check that increased home energy consumption results in reduced diversion to the immersion incoming Live supply cable from the utility meter.
Page 5: Technical Specifications
Children should be supervised to ensure that they do not play with the appliance. Further Support Technical support for qualified installers and electricians, visit: www.marlec.co.uk/troubleshootmysolariboost SIB Energy Limited ⁞ Corby ⁞...