Atmos MissionOne User Manual page 18

8. Warranty & Maintenance
8.1 Screen Guard
To apply a screen Guard:
1) Clean the glass of MISSION ONE.
2) Make sure the green side of the screen guard is on
the top, then apply onto MISSION ONE.
3) Remove the thin green layer.
8.2 Watch Strap
MISSION ONE is compatible with 24mm width strap.
Socket screw: 1.4mm
8.3 Storage and Maintenance
After dive, rinse the MISSION ONE thoroughly with fresh
water. Do not use high-pressure spray in case of
damaging the button and sensor. If the equipment is
covered with dirt, soak it in fresh water and do not use
any solvent or detergent.
As same as other instruments. Do not throw, press,
collide MISSION ONE. Do not expose it to sunlight or
vehicles exposed under sunlight.
Please use the Screen Guard, which can be purchased
from a qualified dealer when you need to replace it.
For storage, fully charge it then turn the MISSION ONE
off. Store it in a the box and avoid collision. Place it in a
cool and ventilated place where is no sunlight exposure.
8.4. Warranty
Limited Warranty
With exception to consumables or parts with limited
resistance, such as the case, the glass, battery and
band, this product is guaranteed to be free from defects
in materials or workmanship for a period of two years
from the date of purchase (the "warranty period"). During
the warranty period, and upon proof of purchase, the
product will be repaired with ATMOS replacement or
refurbished parts, or replaced by a new or refurbished
device of the same or a similar model. To obtain these
warranty services, please take or send the product,
postage paid, with a copy of the sales receipt or other
proof of purchase showing the date of purchase, to a
member of the ATMOS International Warranty Network
or the store where purchased. As the product may get
damaged or lost in shipping, it is recommended that the
product be packaged securely and sent by insured
parcel post, return receipt requested.
18