❖ Silicone strap (24mm width compatible) alarm system provides instant vibration and intuitive display notification. Equipped with GPS and digital compass make users stay oriented underwater and meanwhile upload dive site’s GPS location to ATMOS’s divelog App above surface. Robust and sleek, it’s the ...
2.4. Diving Safety 2. Basic Operation ● Pleaser read this manual thoroughly and make sure you understand the operation, display, 2.1. Turing On/Off limitation of the MISSION ONE. Turing On: Hold Button D (bottom-left) for 3 sec. ● All dive gears will fall. It is not whether it will fall Turing Off: ...
5. ATMOS App : : Enter the 6 Pin Codes shown on ● Do not throw, collide, press the MISSION ONE. Do not expose MISSION ONE under the sunlight MISSION ONE. Connected! or left it in a car under sunlight.
Connect MISSION ONE with the charging cable. d. Press U pdate Firmware button. 2. Via ATMOS App(OTA): a. Select your device in the ATMOS APP. b. Press U pgrade button if there’s a new version. ※Due to the signal of bluetooth may be interfered by other devices nearby.
4. Scuba Mode 3.2. Stopwatch 4.1. Screen Layout and Alerts Stopwatch Hold Button C (Bottom-right) Predive Upper-left: Compass degree for 2 seconds in watch mode Left: A scent rate bar Mid-left: Water temp. ▶ S tart : Press Button B. ▶...
Page 8
During Dive Upper-left: Compass degree Mark Compass Hold Button B (Right) to enter Ascent rate bar Left: R ed= mark compass heading fuction. Heading faster than 10m(33ft)/min. Left: Water temperature Press Button A (Upper-right) Upper-right: NDL (No Mark heading degree Decompression Limit) Press Button B (Right): Mid:...
Page 9
Time Alarm Notify when dive time is Safety Stop Pause Ascend above 3m or descend reached. below 7m during a safety stop. Safety Pause will show and the countdown will pause. Depth Alarm Notify when depth is reached. Safety Stop Clear Notify when safety stop is completed.
Page 10
Decompression Stop Decompression stops are MOD is the maximum mandatory stops that allowable depth of the current Needed must be followed in order to breathing gas as determined by reduce the risk of PPO2 limits. decompression illness (DCI) Must ascend when seeing The “6m”...
4.2. NITROX 4.4. Conservatism Press Button B (Right) to enter A dvanced Setting in Press Button B (Right) to enter A dvanced Setting in scuba mode. Then find the A ir/Nitrox (21-40%) setting scuba mode. Then find the C ONSERVATISM setting. and ...
Advanced Setting: 5.1. Display Layout and Alerts Conservatism (See 4.4 conservatism) Air/Nitrox (See 4.2 Nitrox) Press Button A (Upper-Right) Predive to view Time Alarm settings. Dive Planner (See4.3 Dive Planner) Press Button C (Bottom-Right) to view Depth Alarm settings. Water Type Salt or freshwater.
Page 13
Surface Rest Upper-left: D ive count Rest Finished Mid-left: M ax depth of last dive Dive Depth 1m-30m (3ft - 100ft) N otify user when the Bottom-left: Water temp Upper-right: D ive time of last Surface Time reaches 2 times dive of the dive time of last dive.
5.2. Time Alarm 5.5. Advanced Setting Press Button B (Right) to access Advanced setting in Press Button B (Right) to enter advanced setting. Freedive mode to set Time Alarms. !!! D o not change any setting until you understand the 5.3.
During Dive Upper-left: Compass 6. Gauge Mode degree Mid-left: Max depth Bottom-left: Water Gauge Mode turns the MISSION ONE into a depth and temperature time display. Decompression calculation will not be Upper-right: Dive time performed. Right: Dive depth Bottom-right: Bottom timer !!!...
6.2.Bottom Timer Button A (Upper-right): Mark heading degree During diving, press Button C (bottom-right) to reset Button B (Right): Return stopwatch. Button C (Bottom-right): Unmark 6.3. Advanced Setting Pressing Button B (Right) to enter advanced setting in Gauge mode prior to desecnt. !!!...
Page 17
2) Go to nearby site function in 7. GPS and E-Compass the advanced setting under each dive mode. The GPS function is designed to mark the entry/exit 3) Wait for the GPS signal ( it coordinate and guide divesite where is in a wide and may take sometime due to the top-open area.
Page 18
(the “warranty period”). During Socket screw: 1.4mm the warranty period, and upon proof of purchase, the product will be repaired with ATMOS replacement or refurbished parts, or replaced by a new or refurbished 8.3 Storage and Maintenance device of the same or a similar model.
Page 19
WARRANTY. NOTHING IN THIS WARRANTY NEITHER THIS WARRANTY NOR ANY OTHER AFFECTS YOUR STATUTORY RIGHTS. WARRANTY OR GUARANTEE, EXPRESS OR THANK YOU FOR CHOOSING ATMOS IMPLIED, INCLUDING ANY IMPLIED WARRANTY OR www.atmos.app CONDITION OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXTEND BEYOND THE WARRANTY PERIOD.
Page 20
Dive mode: Up to 40 hours 8.5. Specification (backlight off) Backlight on: 15 Hours (backlight Battery life General mid) Watch mode: Up to 15 days Smartwatch mode: Up to 10 days Model Model MISSION ONE (KD2) Memory 100 Dive Logs easurements 50.5 x 50.5 x 18 mm English/ Simplified Chinese/...
Page 21
Smart ✔ (iOS, EN/CN/JP/KR) Notification Dive ascent rate ✔ monitor Smartphone iPhone®, Android™ compatibility No fly time ✔ Compatible with Surface Time ✔ ✔ ATMOS™ Mobile Dive Planner ✔ ✔ (configurable time and Diving Features Backlight intensity; auto-on at depth)
Page 22
Warranty period Lock compass ✔ index What's in the box? Save dive entry and exit GPS ✔ ATMOS MISSION ONE with coordinate silicone strap What's in the box Charging Cable GPS dive spot ✔ (Surface use only) Scratch Guard (2pcs)