Setup Using A Terminal Program - VCS VideoJet 10 Manual

Installation

Setup using a terminal program

Data terminal
"
"
Terminal
configuration
26
A data terminal may be connected to the VideoJet 10 for setup and
local control. The data terminal usually consists of a computer with
suitable terminal software. The standard serial null-modem cable
included in delivery is required for the connection.
HyperTerminal, which comes with Windows, can be used as the ter-
minal program.
Note
Information on the installation and use of HyperTerminal can be
found in the documentation or in the Online Help for MS Windows.
Before working with the terminal program, isolate the unit from the
data network.
Connect the sub-D socket COM1: RS232/485 of the VideoJet 10 to
a free serial port on the computer.
To establish communications between the Terminal program and
the VideoJet, the transmission parameters must be correctly setup.
The following parameters should be selected in the Terminal pro-
gram:
19,200 Baud
!
8 Data bits
!
No parity check
!
1 Stop bit
!
No protocol
!
VideoJet 10