Rpr Port Configuration Tasks - H3C S9500 Series Operation Manual

Operation Manual – Port
H3C S9500 Series Routing Switches
RPR supports plug and play, and can bear services almost without configurations. In
general, you do not need to configure RPR. For some special purposes such as
debugging, you can also modify the configuration by referring to the related commands.

5.2.2 RPR Port Configuration Tasks

The following table describes RPR port configuration tasks.
Table 5-1 RPR port configuration tasks
Configuration steps
Enter system view
Enter RPR logical port
view
Configure
names
Configure
switchover on the port
Test node connectivity
Configure default RPR
ring ID
Command
system-view
Interface
interface-number
station
rpr station-name string
rpr admin-request { fs |
forced
ms | idle } { ringlet0 |
ringlet1 }
rpr echo
mac-address
station-name namestring }
[-c value] [-s value] [-r
value ] [-t value ]
rpr default-rs { ringlet0 |
ringlet1 }
5-2
Chapter 5 RPR Port Configuration
Description
-
Required.
physical port view, you
rpr
need to add ".1" and ".2" to
the end of the logical port
name.
Optional
Optional. Note that the
receiving
sub-rings for port 1 on the
panel are Ringlet0 and
Ringlet1 respectively. The
receiving
sub-rings for port 2 on the
panel are Ringlet1 and
Ringlet0 respectively. Here
Ringlet0 and Ringlet1 are
both receiving sub-rings.
{ mac
|
Optional
Optional. Default selection
rings are
sub-rings.
To enter
and sending
and sending
all sending