Table of Contents
Advertisement
Check parts in box against parts
list to insure all components are
present.
1. Position the mounting washer (7) on
the mounting post location, four
places. (Due to manufacturing
tolerances of the mounting post
location(slot), one may need to
remove excessive paint or casting
burr.) Make sure bronze washer is
fully seated on Mounting Post
Location. (Tap bronze washer into
slot if needed, after slot has been
cleaned. )
2. Insert mounting posts (4) through
the mounting washers (7) and into
mounting post locations. Rotate
mounting post 90° or ¼ of a turn
and tighten the post nut by hand,
securing the post in position.
3. Place the passenger side supporting
rail weldment (3) onto the mounting
posts(4). Place the 1/2" pin (6)
through weldments and lock into
place with pin clip (9). Repeat step
for driver side. Note: Adjust the
post nut so that the supporting rail
weldments rest on the nut and not
the hitch pin.
INSTALLATION
Mounting post location(slot)
Face the gusset inboard.
Advertisement
Table of Contents
