Installing The Boom Rail And Opener - Schartec Move 600 Installation And Operating Instructions Manual

Installing the boom rail and opener

STEP 1 (Figure 8)
Attach the opener to the boom rail using the motor shaft sleeve (A).
Secure the rail to the opener with the 2 "U" brackets and the 6 mm
nuts (F) supplied.
STEP 2 (Figure 8)
Place the boom rail and opener assembly centrally on the garage
floor with the opener opposite the garage door. Lift the front of the
rail up to the wall bracket. Insert the clevis pin and secure it with
the split pin supplied (C).
STEP 3 (Figure 9 and 10)
Place the Easy-Click bracket anywhere along the rail. Position it
where you would like to mount the boom to the ceiling (generally
towards the motor end). Once the bracket is in position, twist until
the bracket 'clicks' into position like in Figure 10, then bend the 2
side pieces under to secure the bracket to the boom (also in Figure
10).
STEP 4 (Figure 11)
Lift and support the opener with a ladder so it is positioned
centrally and level.
WARNING: Do not allow
opener or supporting ladder -- serious injury and/or damage
may result from failure to follow this warning.
Figure 8
children around the
37
door,
Figure 9
Figure 10
Figure 11